Introduction
This page provides work instructions on how to setup the TDH335034 Series Pressure Transmitter powered by the Element-C.
Prerequisite: Sensor must already be installed in gas line, cable must be procured by customer.
Materials
- 2-wire TDH33 Series Pressure Transducer
- TDPSCX-01M cable
- Element-C
Procedure
1. Carefully remove the contents from its packaging. If any of the contents looks damaged, please send a picture of the contents to help@elementalmachines.com.
2. Plug in the Element-C and complete the Wifi Connect instructions.
3. Slightly loosen the screws in SLOTS 1 and 9 on the green terminal block on the Element-C.
4. Insert the BLACK wire of the TDPSCX-01M cable into SLOT 1 of the green terminal block on the Element-C. Tighten the screw to ensure that the wire is secure in the slot.
5. Insert the RED Wire of the TDPSCX-01M cable into SLOT 9 of the green terminal block on the Element-C. Tighten the screw to ensure that the wire is secure in the slot.
6. Secure the two unused wires (white and yellow) out of the way:
7. If not already connected, snap in the 3-pin connector to the installed pressure sensor:
8. Set up any desired alerts.