Introduction

This page provides work instructions on how to setup the Rotarex SGB-2 Level Gage powered by the Element-C.

Materials

  • Element-C
  • Connection Cable
  • Rotarex SGB-2 (may already be onsite)

Equipment

  • Small flathead screwdriver

Procedure

  1. Carefully remove the contents from its packaging.  f any of the contents looks damaged, please send a picture of the contents to help@elementalmachines.com. 
  2. Plug in the Element-C and complete the Wifi Connect instructions (see attachment). 
  3. Slightly loosen the screws in SLOTS 1, 2, and 9 on the green terminal block on the Element-C.
  4. Insert the GRAY wire of the Connection Cable  into SLOT 1 of the green terminal block on the Element-C. Tighten the screw to ensure that the wire is secure in the slot.
  5. Insert the ORANGE Wire of the Connection Cable into SLOT 2 of the green terminal block on the Element-C. Tighten the screw to ensure that the wire is secure in the slot.
  6. Insert the GREEN Wire from Vaisala Cable into SLOT 9 of the green terminal block on the Element-C. Tighten the screw to ensure that the wire is secure in the slot.                                            Figure 1: Rotarex connection cable wiring into Element-C
  7. Attach the free end of the Rotarex Cable to the communication port on the side of the Rotarex SGB-2 Level Gage.        Figure 2: Connect free end of cable to the communication port on the side of the Rotarex Level Gage